Memory - HP Sprout Pro Maintenance & Service Manual

Table of Contents

Advertisement

Memory

Two memory module sockets (2) are located under the memory cover under right rear cover. You do not have
to remove the computer from the column to replace the memory modules.
SODIMMs are small outline dual-inline memory modules. SODIMM modules must meet the following
requirements:
DDR4-2400 non-ECC unbuffered SODIMMs (204 pin)
1.2 V memory only
16 GB maximum installable memory
NOTE:
Because the memory uses dual channels, you must use the same SODIMM type for both sockets.
The actual memory transfer speed might vary based on the processor used in your computer.
Memory performance might vary due to different system configurations.
To remove a memory module:
1.
Prepare the computer for disassembly (see
2.
Remove the right rear cover (see
Preparing to disassemble the computer on page
Removing the rear covers from the computer on page
23).
24).
Memory
29

Advertisement

Table of Contents
loading

Table of Contents