Selecting The Type Of I/O - Emerson FloBoss 107 Instruction Manual

4.5

Selecting the Type of I/O

Issued Feb-07
To connect the wire to the removable block compression terminals:
Strip ¼ inch of insulation from the wire.
1.
Insert the bare end into the clamp beneath the termination screw.
2.
Tighten the screw, taking care not to over-torque it.
3.
Expose a minimum of bare wire to prevent short circuits. Allow some
slack when making connections to prevent strain.
: Twisted-pair cable is recommended for I/O signal wiring.
Note
Using ROCLINK 800, you select the type of input or output.
Log on to the FB107 using ROCLINK 800.
1.
: ROCLINK 800 provides an enhanced graphical user interface
Note
(GUI) for the FB107. This interface displays an image of the
FB107 above a tabbed screen (see Figures 4-4 and 4-5). You
select the FB107 module and then use the tabbed screen to
configure the components.
2. Click the I/O module. The display immediately under the FB107
image changes to reflect your selection.
: Figure 4-5 shows the default values for an I/O module.
Note
Inputs/Outputs and RTD Input
FloBoss 107 Instruction Manual
4-7