Kramer 691 User Manual page 58

11.3.1.11 AV-SW-TIMEOUT
Functions
AV-SW-TIMEOUT
Set:
AV-SW-TIMEOUT?
Get:
Description
Set: Set auto switching timeout
Get: Get auto switching timeout
Response
~nn@AV-SW-TIMEOUTSPaction,time_outCR
Parameters
action – event that triggers the auto switching timeout:
2 (audio signal lost)
3 (Audio signal detected)
4 (disable 5V on video output if no input signal detected)
6 (audio cable unplugged)
timeout – timeout in seconds: 0-60000
Notes
The timeout must not exceed 60000 seconds.
K-Config Example
Set the auto switching timeout to 5 seconds in the event of no input signal detected:
"#AV-SW-TIMEOUT 4,5",0x0D
11.3.1.12 DISPLAY
Functions
Set: -
DISPLAY?
Get
Description
Set: -
Get: Get output HPD status
Response
SPout_id,statusCR LF
~nn@DISPLAY
Parameters
out_id – 1 (Out)=
status – HPD status according to signal validation : 0 (Off), 1 (On), 2 (On and all parameters are stable
and valid)
Response Triggers
A response is sent to the com port from which the Get was received, after command execution and:
After every change in output HPD status from On to Off (0)
After every change in output HPD status from Off to On (1)
After every change in output HPD status form Off to On and all parameters (new EDID, etc.) are stable and
valid (2)
K-Config Example
Get the output HPD status of HDMI Out:
"#DISPLAY? 1",0x0D
52
Permission
End User
End User
Syntax
#AV-SW-TIMEOUTSPaction,time_outCR
#AV-SW-TIMEOUT?SPactionCR
Permission
-
End User
Syntax
-
#DISPLAY?SPout_idCR
Transparency
Public
Public
Transparency
-
Public
691 - Protocol 3000