Removing A 2.5 Inch Drive From A 3.5 Inch Drive Adapter - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 33. Installing a drive into the drive carrier
Related link
Removing a drive blank
Installing the front bezel

Removing a 2.5 inch drive from a 3.5 inch drive adapter

Prerequisites
1 Follow the safety guidelines listed in
2 Remove the 3.5 inch drive adapter from the 3.5 inch drive carrier.
NOTE: A 2.5 inch drive is installed in a 3.5 inch drive adapter, which is then installed in the 3.5 inch drive carrier.
Steps
1 Using the Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
2 Remove the 2.5 inch drive from the 3.5 inch drive adapter.
84 Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
Safety instructions.