Dell EMC PowerEdge T440 Installation And Service Manual page 64

Redundant OS Control
You can use the Redundant OS Control screen to set the redundant OS info for redundant OS control. It enables you to set up a physical
recovery disk on your system.
Viewing Redundant OS Control
To view the Redundant OS Control screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Redundant OS Control.
Redundant OS Control screen details
The Redundant OS Control screen details are explained as follows:
Option Description
Redundant OS Enables you to select a backup disk from the following devices:
Location
•
•
•
•
•
Redundant OS
State
When set to Visible, the backup disk is visible to the boot list and OS. When set to Hidden, the backup disk is
disabled and is not visible to the boot list and OS. This option is set to Visible by default.
Redundant OS Boot
When set to Enabled, BIOS boots to the device specified in Redundant OS Location. When set to Disabled, BIOS
preserves the current boot list settings. This option is set to Enabled by default.
64 Dell EMC PowerEdge T440 Installation and Service Manual
Pre-operating system management applications
None
IDSDM
SATA Ports in AHCI mode
BOSS PCIe Cards (Internal M.2 Drives)
Internal USB
NOTE: RAID configurations and NVMe cards not are included as BIOS does not have the ability to
distinguish between individual drives in those configurations.
NOTE: This option is disabled if Redundant OS Location is set to None.
NOTE: BIOS will disable the device in hardware, so it cannot be accessed by the OS.
NOTE: This option is disabled if Redundant OS Location is set to None or if Redundant OS State is set
to Hidden.