Table of Contents
Advertisement
Figure 44. Removing a drive blank
Next steps
1.
Installing a drive blank
Installing a drive blank
The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical.
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
Removing the front bezel
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 45. Installing a drive blank
Next steps
If removed,
Installing the front bezel
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in
2.
Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Safety
instructions.
Safety
instructions.
Installing and removing system components
55
Advertisement
Table of Contents
