Download  Print this page

Initial System Setup And Configuration; Setting Up Your System; Idrac Configuration; Options To Set Up Idrac Ip Address - Dell EMC PowerEdge T440 Installation And Service Manual

Hide thumbs

Advertisement

Setting up your system

Complete the following steps to set up your system:
1
Unpack the system.
2
Install the system into the rack. For more information about installing the system into the rack, see the Rail Installation Guide at
Dell.com/poweredgemanuals.
3
Connect the peripherals to the system.
4
Connect the system to its electrical outlet.
5
Turn the system on by pressing the power button or by using iDRAC.
6
Turn on the attached peripherals.
For more information about setting up your system, see the Getting Started Guide that shipped with your system.
Related link

iDRAC configuration

Options to set up iDRAC IP address

iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell systems. iDRAC alerts administrators to system issues, helps them perform remote system management, and reduces the
need for physical access to the system.
Options to set up iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC.
You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP
for iDRAC. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
See Dell Integrated Dell Remote Access Controller User's Guide at
utility
Dell Deployment
See Dell Deployment Toolkit User's Guide at
Toolkit
Dell Lifecycle
See Dell Lifecycle Controller User's Guide at
Controller
CMC Web interface
See Dell Chassis Management Controller Firmware User's Guide at
NOTE:
To access iDRAC, ensure that you connect the Ethernet cable to the iDRAC direct port. You can also access iDRAC
through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.
40
Dell EMC PowerEdge T440 Installation and Service Manual

Initial system setup and configuration

Initial system setup and configuration
Dell.com/idracmanuals
Dell.com/openmanagemanuals
Dell.com/idracmanuals
Dell.com/cmcmanuals
5

Advertisement

   Related Manuals for Dell EMC PowerEdge T440

Comments to this Manuals

Symbols: 0
Latest comments: