Installing A Drive Into The Drive Carrier - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 32. Removing the drive from the drive carrier
Next step
If applicable, install the drive into the drive carrier.
Related link
Removing the front bezel

Installing a drive into the drive carrier

Installing a drive blank
Installing a drive into the drive carrier
Installing a drive into the drive carrier
Prerequisites
Follow the safety guidelines listed in
CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE: When installing a drive into the drive carrier, ensure that you do not tighten the screws to more than 4 in-lbs.
Steps
1 Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2 Align the screw holes on the drive with the screws holes on the drive carrier.
When aligned correctly, the back of the drive is flush with the back of the drive carrier.
3 Using the Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
Safety instructions.
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
83