Optional Internal Usb Memory Key; Replacing Optional Internal Usb Memory Key - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 60. Installing the external cooling fan
Next steps
1 Install the air shroud.
2 Follow the safety guidelines listed in
Related link
Installing the air shroud
Removing the air shroud

Optional internal USB memory key

An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Related link
System board jumpers and connectors

Replacing optional internal USB memory key

Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see the Internal USB memory key (optional) section.
2 If installed, remove the USB memory key from the USB port.
3 Insert the replacement USB memory key into the USB port.
112 Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
Safety instructions.
Safety instructions.
Before working inside your system.