Installing The Air Shroud - Dell EMC PowerEdge T440 Installation And Service Manual

NOTE: Systems with x16 hard-drive backplanes use a different air shroud. To ensure proper cooling, always install the
air shroud provided with your system.
Figure 26. Removing the air shroud
Next step
Install the air shroud.
Related link

Installing the air shroud

Installing the air shroud
Prerequisites
1 Follow the safety guidelines listed in
2 If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing bracket.
Steps
1 Align the tabs on the air shroud with the securing slots on the chassis.
2 Lower the air shroud into the chassis until it is firmly seated.
NOTE: When the cooling shroud is properly seated, the chassis intrusion-switch on the cooling shroud connects to the
chassis intrusion-switch connector on the system board.
Safety instructions.
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
77