Installing A Cabled Drive - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 44. Removing a cabled drive
Next steps
1 Follow the procedure listed in
2 Install the internal drive bay into the chassis.
3 If disconnected, reconnect the power and data cable(s) to the remaining drive(s) in the internal drive bay.
Related link
Removing the internal hard drive bay
Installing the internal hard drive bay

Installing a cabled drive

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the internal drive bay.
Steps
1 Insert the drive into the internal drive bay with the drive connector facing outward.
2 Secure the drive to the internal drive bay using the four screws.
NOTE: When installing new drives into the internal drive bay, use the spare drive screws attached to the drive bay.
After working inside your system.
Safety instructions.
Before working inside your system.
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
95