Table of Contents
Advertisement
Figure 28. Installing a drive into the drive carrier
Related links
Removing a drive blank
Installing the front bezel
Removing a 2.5 inch drive from a 3.5 inch drive adapter
Prerequisites
1
Follow the safety guidelines listed in
2
Remove the 3.5 inch drive adapter from the 3.5 inch drive carrier.
NOTE:
A 2.5 inch drive is installed in a 3.5 inch drive adapter, which is then installed in the 3.5 inch drive carrier.
Steps
1
Using the Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
2
Remove the 2.5 inch drive from the 3.5 inch drive adapter.
76
Installation and Service Manual
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
