Removing The Drive From The Drive Carrier - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 31. Installing a drive carrier
Next step
If applicable, install the front bezel.

Removing the drive from the drive carrier

Prerequisite
Follow the safety guidelines listed in
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Using Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
82 Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
Safety instructions.