Installing Caster Wheels - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 22. Removing caster wheels
Next step
Install the caster wheels or the system feet, as applicable.
Related link
Installing the system feet

Installing caster wheels

Installing caster wheels
Prerequisites
1 Follow the safety guidelines listed in
2 Place the system on its side on a flat, stable surface.
3 If installed, remove the system feet.
Steps
1 Align the two retention hooks on the rear wheel unit with the two slots on the base of the system, and insert the hooks into the slots.
2 Push the rear wheel unit toward the back of the system and using a Phillips #2 screwdriver secure the unit in place using a single
screw.
3 Align the two retention hooks on the front wheel unit with the two slots on the base of the system, and insert the hooks into the slots.
4 Push the front wheel unit toward the front of the system and using a Phillips #2 screwdriver secure the unit in place using a single
screw.
Safety instructions.
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
73