Infeed Table Adjustment - Craftex CX12HC User Manual

Tilt the fence inward as far as possible and
use a combination square to check if the
fence is tilted 45° inward to the table.
If an adjustment is necessary, loosen the
lock nuts and adjust the bolts shown in
figure-10 until tip of the bolts contact the
brackets.
Figure-10 45° inward positive stop
Now, rotate the tilt stop plate to up position
and tilt the fence outward as far as
possible. Use a combination square and to
check if the fence is tilted 45° outward.
If an adjustment is necessary, loosen the
lock nut and adjust the bolt shown in figure-
11 until head of the bolt contacts back of
the fence.
Figure-11 45° outward positive stop
Tighten the lock lever to secure the fence in
position.
12
INFEED TABLE
ADJUSTMENTS
To raise or lower the infeed table, loosen
the table lock lever. See figure-12.
Move the table height lever up or down until
the table is at the desired position and
tighten table lock lever. See figure-12.
Figure-12 Infeed table height controls
The depth of cut depends on the position of
the infeed table in relationship with the
cutterhead and it can be read on the pointer
and scale. See figure-13.
Figure-13 Infeed table height adjustment
Positive stops are provided on the jointer to
limit the height and depth of the infeed
table. To adjust the stops, loosen two
locknuts and shown in figure-14. Turn the
two adjustment bolts as necessary.