Adtech QS2 Series Manual page 49

No. Parameter name
Internal speed 4 The set speed is 4 when operating in a internal 4-stage
P38
Internal
P39
position 1
Internal
P40
position 2
Internal
P41
position 3
Internal
P42
position 4
P43 Correspondence
address
Communication
baud rate
P44
Torque arrival
P45
percentage
Percentage of
P46
motor static
torque
P47 Open delay of the
electromagneti
c brake
speed control mode;
The set speed is 1 when operating in an internal 4-
stage speed control mode;
The set position is 2 when operating in an internal 4-
stage position control mode;
The set position is 3 when operating in an internal 4-
stage position control mode;
The set position is 4 when operating in an internal 4-
stage position control mode;
1
0--4800,1-9600,2-14400,3-19200,4,5-38400,6-57600,
7-115200;
Set the proportion between the set analog quantity
torque input voltage and the actual motor
operating torque;
Unit of the setting value is 0.1V/100%;
Default value is 100 with 10V/100%，which means
inputting 10V voltage will generate 100% rated
torque;
The torque of shaft locking when motor stops;
The unit of setting value is when the position loop is
valid , the speed loop and torque loop are invalid; the
set unit: the rated torque× 100%;
0－disable this function;
Other values—this function available
Reservation function not available for now
QS2 Series Low Voltage Servo Drive
Function
49
Range
0－5000
0－± 32000
0－± 32000
0－± 32000
0－± 32000
0－255
0－7
0－100
0－100
0－32000