Dial Switch - Adtech QS2 Series Manual

4.2 DIP Switch
QS2 series dial switch is as follows:
SW1 SW2
00=P+D 100khz
01=CCW+CW 100khz
10=A+B 100khz
11= P+D
Note: 0= OFF, 1= ON
Note 1: Switch1 and 2 are for the selection of pulse mode, Switch 3 is for the selection of
communication mode, and Switch 4 is for the selection of communication baud rate and
communication station number. For details, please refer to Chapter 5.
Note 2: When the baud rate and communication mode needs changing, the drive shall be
electrified again.
Note 3: When SW1 SW2=00, only the PLC frequency and the pulse within 100KHZ can be
received; and when SW1 SW2=11, both PLC frequency and the pulse within 500KHZ can be
received.
SW1
SW3
0=RS232 0= 9600bps in default, communication station No.1
1=RS485 1=custom, related with the drive internal parameters
500Khz
QS2 Series Low Voltage Servo Drive
OF
F
SW2 SW3 SW4 ON
27
SW4