Parameter Setting Of Drive Software; Parameter Setting - Adtech QS2 Series Manual

Low-voltage servo drive
Table of Contents

Advertisement

It shall be set as 1 in default in communication station number parameter
management software and the drive. "Connect" the motor to communicate after
setting of the communication parameters.
5.3 Parameter settings
(1) After connecting the communication successfully, the basic state of the motor
running is displayed on the drive status screen; you can check if the machine has
failure according to the status of the servo system running; the interface is as
follows;
通讯端口
Communication baud rate selection
Communication interface
QS2 Series Low Voltage Servo Drive
Communication interface
33

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the QS2 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents