Control Switches - CORRECT CRAFT super air 230 2018 Owner's Manual

Section 3
• Tachometer/Hour Meter - Registers engine speed in
revolutions per minute (RPM). Use the tachometer to keep
the engine within the proper operating range. Consult the
engine manual for the proper RPM operating range of your
engine. The hour meter LCD display registers accumulated
engine operating time. Time will not be logged unless the
ignition switch is on and the engine is running. Use the hour
meter to keep accurate logs for scheduled maintenance.
• Speedometer - Your Nautique is equipped with a precision
speedometer by Faria. This gauge registers forward speed in
miles per hour (optional kilometers per hour). The
speedometer is equipped with an adjustment knob to
calibrate speedometer accuracy. You can also use this gauge
to monitor fuel consumption and propeller performance.
• Engine Warning Light - Indicates high engine temperature. If
light illuminates, stop engine and investigate for cause.
• V-Drive Warning Light - Indicates low oil pressure in V-Drive.
If light illuminates when the engine is in gear and above
1200 rpm, stop engine and check V-Drive oil level.

Control Switches

Each electrical circuit on your boat is equipped with a control
switch. The switches have an indicator light for easy ON/OFF
identification. All switches are protected by circuit breakers.
If a short is detected, the associated LED will flash on the
buttonpad. To reset the circuit, turn off the offending load, stop
the engine, then hold the STOP button for a couple of seconds
until the flashing stops. For PDM-driven loads, or loads like the
HORN that do not have a dedicated LED, the backlights flash
instead.
3-8