CORRECT CRAFT super air 230 2018 Owner's Manual page 177

CAUTION
trailering and before storage. To prevent pooling, do not
allow snow and ice to accumulate on the cover.
Never trailer at speeds above the speed limit.
Proper installation and operation of this cover requires that it be
very tight at the gunwale. Retighten as necessary before, after and
during stops while trailering.
BE SURE cover is installed below gunwale before final ratchet
adjustment. ZIP ratchet pocket closed for final installation.
hand tightened only. Do not pry or attempt to operate
ratchet mechanism with any type of tool.
Removal Instructions
•
Zip open ratchet pocket and release pressure on ratchet.
•
Once pressure is released pull out webbing to allow simple
future installation, then close handle and ZIP POCKET (this
is important to prevent damage in future installation).
•
Remove cover from cleat reinforcements and fold cover
working from rear to front.
•
Disconnect anti-pooling pole from either the front (colored
webbing) or back.
•
After disconnecting collapse poles by pushing buttons and
telescoping them down.
•
Wrap webbing around poles.
Warranty
This cover includes a two year warranty from date of purchase
against any defects in material or workmanship. If you incur any
problems or have any comments please contact your dealer or call
Commercial Sewing Customer Service directly at (860) 482-5509.
Controls and Indicators
Readjust and retighten the cover after
Zippered ratchet mechanism should be
3-41