Rudder Remote Lube Fitting; Checking Transmission Fluid - CORRECT CRAFT super air 230 2018 Owner's Manual

Rudder Remote Lube Fitting

The remote lube fitting allows for easy access to lubricating the
rudder. The remote lube fitting is located at the stern of the engine
compartment. Use a quality marine grease and gun. Connect the
grease gun to the fitting and apply a light pressure to the gun until
you feel a slight resistance.

Checking Transmission Fluid

1. The fluid level must be checked in one of the following
conditions:
A. Engine/Transmission is cold;
B. Engine/Transmission has been shut off for at least 2
minutes to allow fluid to drain back.
2. Remove the dipstick by turning the T-handle counterclockwise.
Wipe the dipstick off using a clean cloth.
3. Re-insert the dipstick to the threads (DO NOT screw the dipstick
in) and remove. Observe the fluid level.
4. The fluid level should be at the "FULL" mark. If low, add the
specified fluid in small increments through the dipstick hole in
the transmission. Repeat the checking procedures until the
fluid level is at the "FULL" mark.
5. Replace the dipstick and tighten securely.
Care and Maintenance
FULL
ADD
CORC0617
7-19