Bilge Pump(S); Visual Distress Signals - CORRECT CRAFT super air 230 2018 Owner's Manual

Bilge Pump(s)

Bilge pump(s) are installed in your boat to remove water that may
accumulate in the bilge. Know the location of the pump(s), where
they discharge, and where switches are located. Typically there are
manual switch and/or an automatic switch position(s). Periodically
test the operation of bilge pumps by activating the manual switch
and observing the water discharge. It is best to leave the bilge pump
switches in automatic mode, so as to not allow excess water to
unknowingly accumulate in the bilge of your boat. If your bilge
pump comes on too frequently or continuously, investigate the
source of leaking water (check for hull damage, hose or piping
leaks, missing drain plug, exhaust system or ballast system failures,
etc.), and/or return to shore. Excess water in the bilge of your boat
can cause loss of engine power, sinking, and/or capsizing.

Visual Distress Signals

All vessels used on coastal waters, the Great Lakes, territorial seas,
and those waters connected directly to them up to a point where a
body of water is greater than two miles wide, must be equipped with
USCG approved visual distress signals. Your dealer or local
authorities can help you select appropriate visual distress signals for
your area.
If you are required to carry distress signals, you must have three
USCG approved pyrotechnic devices. Be sure they are in
serviceable condition, not exceeding the expiration date and
stored in a cool, dry location in a red or orange waterproof
container.
fire and/or explosion, death, serious injury, and property
damage if improperly handled. Follow the pyrotechnic
manufacturer's directions.
Boating Safety
Pyrotechnic signaling devices can cause
1-21