CORRECT CRAFT super air 230 2018 Owner's Manual page 176

Section 3
White straps
with buckles
Anti-pooling
pole
To properly install ratchet strap system:
1. Pull the webbing through the channeled ratchet cylinder and
tension completing almost one full cycle to "start" the webbing.
You should see the edge of the rear channel cylinder and the
front cylinder is wrapped with webbing. You now have a one-
way strap. Pull the end of the webbing tight.
2. Pull the sides of cover to even the webbing throughout. Pull the
end of the webbing tight again.
3. Crank the ratchet until taught. Zipper pocket closed.
4. Check the boat webbing for tension during stops while
trailering.
NOTE: Webbing may stretch during first installation and
use. Check webbing often.
3-40
Handle
or Cleat
Handle
or Cleat
Black
straps
FRONT
CORC0730