Speedometer Calibration; Control Switches - CORRECT CRAFT Super Air 210 2011 Owner's Manual

Section 4
Service Soon Light - For quality control check. When ignition is
turned on without cranking the engine, the red "check engine"
light will turn on for a few seconds and then turn off. The amber
"service soon" light will turn on and stay on until either the engine
is started or the ignition is switched off. When the engine is
running, both lights will be off. The amber "service soon" light will
come on if there is a problem with the catalyst system. The red
"check engine" light will come on for all other engine-related
problems.

Speedometer Calibration

The speedometer calibration control knob is located on the under
side of the deck beneath the dash pod above the driver's right knee.
Drive the boat at a known speed using a GPS or measured course
and adjust the knob until the speedometer is reading correctly.
Turning the knob one direction will raise the needle reading while
turning it in the other direction will lower the reading.

Control Switches

Each electrical circuit on your boat is equipped with a control
switch. The switches have an indicator light for easy ON/OFF
identification. All switches are fuse protected.
Engine Compartment/Bilge Area Blower
The "BLOWER" switch activates the engine compartment
ventilation blower to remove explosive fumes from the area. The
blower is turned on by pressing and releasing the "BLOWER"
switch. Press again to turn off. The blower must be operated for a
minimum of four minutes each time before starting the engines or
generator. In addition, the blower should be operated continuously
when at idle or running at slow speeds.
!
vapors can cause death or serious injury from failure to
check for fumes in the engine compartment or operating
the blower. Before engine start-up, check engine
compartment for gasoline vapors, then operate blower
for at least four minutes. Operate blower whenever
below planing speed.
4-8
Explosion and fire hazard from gasoline