CORRECT CRAFT super air 230 2018 Owner's Manual page 175

Installation Instructions
These instructions apply based upon model and year.
A. Anti-Pooling System Installation:
Install the anti-pooling system as per the illustration on page 3-40
connecting the side release buckles around the rear boarding
handles and stand the rear pole upright. Work your way to the front
of the boat. For an open bow extend the front pole completely. For
the closed bow remove and discard the 7/8" pole and use only the
3/4" pole and attach the pole end onto the 3/4" pole. Pull the other
two webbing straps to the two front handles and connect the side
release buckles around handle. For the 200 feed the strap around
the BOW eye (underneath the gunwale) and connect to the
opposite side. Tighten adjustable buckle strap until the pole stands
upright.
B. Proper Cover Installation:
Place the cover on the boat starting at front, use front cleats or front
lift eye openings as buttons to keep cover in place, work toward
back over anti-pooling system until cleats are "buttoned" in place.
Connect the side release buckles and the hook+loop around the
base of the tower. Refer to the following drawings for connecting
the zipper around the tower.
Maneuver in place until cover fits over gunwale. Check the
symmetry.
Controls and Indicators
Place drop of
lubricant
as shown
to both sides
(top & bottom
in this picture)
CORC0729
3-39