CORRECT CRAFT super air 230 2018 Owner's Manual page 148

Section 3
Unlocked Mode
Unlocked mode is entered after the user successfully enters the user
code, presses and releases the start key. When the code keys are
pressed, the system indicator light will turn ON while the key is
pressed. This indicates the key has actually been pressed. When the
system is unlocked, power is supplied to the boat and the system
indicator light will turn ON. At this point all keypad keys will operate
and actuating these keys will control the corresponding boat
functions. To put the unit back in Locked Mode, the user must
successfully enter the user code, then press the STOP key. This will
turn off the system indicator light and shut off power to all of the
accessories except the horn, bilge pump, bilge blower and code keys.
Run Mode
Enter the Unlocked Mode.
Pressing and releasing the START key quickly will put the unit in
Run Mode. Power is supplied to the engine ignition, but the engine
will not crank and the ignition indicator light is turned ON. If the
start key is not pressed again within 15 minutes, the unit will exit
Run Mode by shutting off power to the ignition and re-enter the
Unlocked Mode. If the user presses the START key, power is
supplied to the ignition and starter until the engine starts or for a
maximum of 5 seconds if the engine does not start. All accessory
keys will operate in this mode. Pressing the STOP key will shut off
the engine and the unit is then put back in the Unlocked Mode.
After the engine starts, release the START key.
CAUTION
DO NOT hold the START key for more
than 30 seconds. The starter motor can be damaged.
Automatic Return to Locked Mode
If no keypad activity takes place for 10 hours after unlocking, the
system will automatically return to the Locked Mode to help
prevent battery drain.
3-12