Dash Pod Switches; Bilge Pump - CORRECT CRAFT Ski Nautique 206 Owner's Manual

Heater
The heater key controls four different heater functions. Pushing and releasing
the "heater" key scrolls from "off" to "low speed" to "medium speed" to "high
speed" and back to "off." The indicator light for this key is on if the heater is
running at any of the three speeds.
Courtesy / Docking Lights
A quick push and release of this key turns on the indicator light and the
courtesy lights, while a push and slight hold turns on the indicator light and the
docking lights. Both the courtesy and docking lights can be turned on at the
same time, but only if the courtesy lights are turned on first. If either or both
of the two light functions are on, please note that the indicator light turns on
and a push and release will turn off any of the lights that are on.
Navigation / Anchor Light
A quick push and release of this key turn on the navigation lights and the
indicator light, while a push and slight hold will only turn on the anchor light
and will also cause the indicator light to flash. A push and release of the key
turns off either of the lights.

Bilge Pump

The bilge pump(s) is turned on or off by pressing and releasing the key. The
indicator light is on whenever the pump(s) is on.
Bilge Blower
The bilge blower is turned on or off by pressing and releasing the key. The
indicator light is on whenever the blower is on.
Horn
The horn key is strictly a momentary switch. The horn will blow whenever the
key is pushed and will stop when the key is released.

Dash Pod Switches

All dash pod switches interface with a sealed circuit breaker box located under
the bow. The circuit breaker box consists of sixteen soft opaque flexible vinyl
tubular shields which cover sixteen circuit switches. When the circuits are
functioning, the tubular shield is somewhat flexible. A tripped circuit breaker
will extend and fill the tubular shield, causing it to be inflexible. To locate a
tripped circuit breaker, run your fingers over the two rows of switches and
locate the switch shield that has become inflexible. To re-set, simply press in
the extended circuit switch shield.
Bilge Pump
The bilge pump switch turns on the bilge pump. There is a bilge pump down
by the pylon as well as one at the rear of the boat near the ruder. When you
1.6 1.6