Agilent Technologies E4980A Service Manual page 147

P
-220 Parameter error
When a parameter-related error other than Errors -221 through -229 occur, this error
message is displayed.
-108 Parameter not allowed
The number of parameters exceeds that required for the command. For instance, when a
program message ":FORM:BORD NORM, ASC" is sent instead of a correct program
message with a command ":FORM:BORD NORM", which requires a parameter, the
instrument receives the message that the number of parameters is invalid. See the
command reference to confirm the required number of parameters.
1080 Power failed
Power unit hardware failure is detected. Contact Agilent Technology's Sales and Service
Office or the company from which you bought the device.
1000 Power on test failed
An error occurs during a self test at power-on. The E4980A may be faulty. Contact Agilent
Technology's Sales and Service Office or the company from which you bought the device.
A self test fails when an interface board is removed or not connected properly. Check the
connection with a cable when you change the setting of the interface board.
-112 Program mnemonic too long
Program mnemonic is too long (maximum length is 12 characters).
Q
-350 Queue overflow
There is no room in the queue and an error occurred but was not recorded. Clear the error
queue.
-430 Query DEADLOCKED
Input buffer and output buffer are full; cannot continue.
-400 Query error
Query is improper.
-410 Query INTERRUPTED
Query is followed by DAB or GET before the response is completed.
-420 Query UNTERMINATED
Addressed to talk, incomplete program message received.
-440 Query UNTERMINATED error after indefinite response
A query that requests arbitrary data response (
normal queries in a program message (for example,
*IDN?;FREQ?
Appendix D
is received).
Error Messages
Error number: -220
*IDN? and *OPT? queries) is sent before
FREQ?;*IDN? is expected, but
147