Mitsubishi Electric MELSEC iQ-R Series Configuration Manual page 162

■ Interrupt pointer setting
"Interrupt Pointer Setting" of GX Works2 changes the following window in GX Works3.
GX Works2
[Project window]  [Parameter]  [PLC Parameter] 
[PLC System]  [Interrupt Pointer Setting]
The interrupt pointer setting method differs as below between GX Works2 and GX Works3.
• The SI No. setting of the interrupt module is not required on GX Works3.
• "Interrupt Pointer" of the interrupt module must be the serial number on GX Works3. (Set I51 on No.2 and I52 on No.3 when
No.1 is set I50.)
APPX
160
Appendix 5 How to Use MELSEC-Q Series Modules
GX Works3
[Navigation window]  [Parameter]  [Module
Information]  Module model name  [Module
Parameter]