Wiring To A Screw Terminal Block - Mitsubishi Electric MELSEC iQ-R Series Configuration Manual

Wiring to a screw terminal block

This section describes the wiring to an 18-point screw terminal block.
Wiring method
Wired cables can be fixed to the 18-point screw terminal block by using a fixing band (width: 3mm, thickness:
1mm or less).
Fix the cables by passing the fixing band (1) to the hole for fixing band (2) as shown below.
1.
Strip the insulating coating of a cable.
2.
Connect a solderless terminal to the stripped part of the
cable. For applicable solderless terminals, refer to the
specifications of each module.
3.
Wire the solderless terminal to an 18-point screw
terminal block. For the terminal layout, refer to the
specifications of each module.
(1)
(2)
5 INSTALLATION AND WIRING
5.7 Wiring
5
125