Creating An Edid - Easy Edid Creator; Control Menu - Lightware HDMI-TPS-TX210 User Manual


  
5. Software Control - Lightware Device Controller
5.6.4. Creating an EDID - Easy EDID Creator
Since above mentioned Advanced EDID Editor needs more complex knowledge about EDID,
Lightware introduced a wizard-like interface for fast and easy EDID creation. With Easy EDID
Creator it is possible to create custom EDIDs in four simple steps. By clicking on the Create button below
Source panel, Easy EDID Creator is opened in a new window. For more details about EDID Editor please visit
our website (www.lightware.eu) and download EDID Editor user's manual.
EDID Creator window
HDMI-TPS-TX200 series – User's Manual
A
5.7. Control Menu
5.7.1. RS-232
Create
The following settings and functions are available on the local and TPS link RS-232 port:
Operation mode: Control, Pass-through, and Command Injection (for more details about serial interface
▪
modes see the
▪ Baud rate: 4800, 7200, 9600, 14400, 19200, 38400, 57600, 115200;
Data bits: 8 or 9;
▪
Parity: None, Odd, or Even;
▪
▪ Stop bits: 1, 1.5, or 2;
Command injection: enable or disable;
▪
Command injection port number;
▪
▪ Control protocol: LW2 or LW3;
▪ Message sending via serial port;
Reloading
▪
ATTENTION! The RS-232 Operation mode is mirrored on the Local and Link serial port. The other settings
can be adjusted separately on the two ports.
RS-232 tab in Control menu
Serial Interface section);
Factory Default Settings.
32