View Connection State On The Output; View Crosspoint Size; Change Video Autoselect Mode; Change Audio Autoselect Mode - Lightware HDMI-TPS-TX210 User Manual


  
6. LW2 Programmer's Reference
6.3.6. View Connection State on the Output
Description: Viewing the crosspoint state of the device; showing the input port numbers connected to the
outputs.
Format
Command {VC●<layer>}
Response (ALL<layer>●<O01>●<O02>)CrLf
Legend: O01 shows the corresponding output's connection state.
<layer>
* AV is not used in the response. When AV is typed in the commands, the response will result two lines, one
for the Video and one for the Audio port states.
State letters:
Letter
L
M
U
Explanation: I2 video input port is connected to the video output port and I5 audio input port is connected
to the audio output port.
6.3.7. View Crosspoint Size
Description: Shows the physical crosspoint size.
Format
Command {getsize●<layer>}
Response (SIZE=<size>●<layer>)CrLf
Legend:
<size>:
<layer>:
Explanation: The device reports that it has a video crosspoint with 6 inputs (Test pattern is the 6th input) and
1 output and an audio crosspoint with 5 inputs and 1 output.
Example
 {VC AV}
 (ALLV 02)
 (ALLA 05)
Layer
A Audio layer
V Video layer
AV * Audio & Video layer
State Example
Output is locked L01
Output is muted M01
Output is locked and muted U01
Example
 {GETSIZE AV}
 (SIZE=6x1 V)
 (SIZE=5x1 A)
<number of inputs>x<number of outputs>
See details in the previous section.
HDMI-TPS-TX200 series – User's Manual
6.3.8. Change Video Autoselect Mode
Description: The autoselect mode of the video outputs can be changed.
Format
Command {AS_V<out>=<state>;<mode>}
Response (AS_V<out>=<state>;<mode>)CrLf
Legend: The output numbers are listed in
Letter <state>
F First detect mode
P Priority detect mode
L Last detect mode
Explanation: The Autoselect mode of video output1 and output 2 is enabled and set to Priority mode.
INFO: The Autoselect mode can be queried by typing the "as_v<out>=?" command.
6.3.9. Change Audio Autoselect Mode
Description: The autoselect mode of the audio outputs can be changed.
Format
Command {AS_A<out>=<state>;<mode>}
Response (AS_A<out>=<state>;<mode>)CrLf
Legend: The output numbers are listed in
Letter <state>
F First detect mode
P Priority detect mode
L Last detect mode
Explanation: The Autoselect mode of audio output1 and output 2 is enabled and set to Priority mode.
INFO: The Autoselect mode can be queried by typing the "as_v<out>=?" command.
Example
 {as_v1=E;P}
 (AS_V1=E;P)
 (AS_V2=E;P)
Port Numbering section.
Letter <mode>
E Autoselect mode is enabled
D Autoselect mode is disabled
Example
 {as_a1=E;P}
 (AS_A1=E;P)
 (AS_A2=E;P)
Port Numbering section.
Letter <mode>
E Autoselect mode is enabled
D Autoselect mode is disabled
45