Installation; Rear Panel; I/O Board Configuration Overview - Extron electronics XTP II CrossPoint 1600 Setup Manual

Installation

This section describes installation of the XTP II CrossPoint matrix
switchers, including connections and features. Topics that are
covered include:

Rear Panel

•
Front Panel
•
Rear Panel
A A
C C
D D
E E
B B
F F
100-240V -- A MAX
50-60Hz
Figure 2.
Input boards
A
Output boards
B
LAN port
C
Remote port
D

I/O Board Configuration Overview

See figure 2,
Input boards are installed in one or two blocks or spaces and output
boards are installed in separate spaces. Each board position is
identified by the input or output numbers supported by the position
(1-2, 5-8, and so on).
On the XTP II CrossPoint 1600, boards are installed horizontally,
input boards in the top space and output boards in the bottom
space. Inputs or output positions are 1-4 on the top space and
13-16 on the bottom space.
On the XTP II CrossPoint 3200 and the XTP II CrossPoint 6400,
boards are installed vertically; input boards on the left and output
boards on the right. Input or output positions are 1-4 in the left
space and 29-32 in the right space. For the XTP II CrossPoint 6400,
input and outputs 33-64 are in the second blocks of boards.
4 XTP II CrossPoint Series • Installation
1−4
5−8
9−12
13−16
REMOTE
LAN
RS-232/RS-422
LINK ACT
1−4
5−8
9−12
13−16
XTP II CrossPoint 1600 Matrix Switcher Rear Panel
(see next page)
(see page 9)
(see page 12)
(see page 12)
figure 3 on the next page, and
RESET
Reset button
E
Power connector
F
Power connector
G
figure 4
(see page 12)
(see page 12)
(see page 12)
on page 6.