Extron electronics XTP II CrossPoint 1600 Setup Manual page 24

HDMI connectors
Use a LockIt Lacing Bracket to securely fasten each HDMI cable to
the matrix switcher as follows:
1. Plug the HDMI cable into the
panel connection (
2. Loosen, but do not remove,
the HDMI connection
mounting screw from the
panel enough to allow the
LockIt to be placed over it
(
2
3. Place the LockIt Lacing
Bracket on the screw and
against the HDMI connector
(
3
secure the bracket.
ATTENTION:
4. Loosely place the included tie wrap around the HDMI connector
and the LockIt Lacking Bracket (
5. While holding the connector securely against the lacing
bracket, use pliers or similar tool to tighten the tie wrap (
then remove any excess length.
16 XTP II CrossPoint Series • Installation
).
1
).
), then tighten the screw to
Do not overtighten the HDMI connector mounting screw.
•
The shield it fastens to is very thin and can easily be
stripped.
Ne serrez pas trop la vis de montage du connecteur
•
HDMI. Le blindage auquel elle est attachée est très fin et
peut facilement être dénudé.
3 3 3
1 1 1
3
4 4 4
5 5 5
).
4
2 2 2
)
5