Extron electronics XTP II CrossPoint 1600 Setup Manual page 25

Local audio connectors
Do not tin the wires!
Figure 7. Audio Input and Output Connector Wiring
ATTENTION:
For unbalanced audio output, connect the sleeves to
•
the ground contact. DO NOT connect the sleeves to the
negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au
•
contact au sol. Ne PAS connecter les manchons aux
contacts négatifs (–).
NOTE:
The length of exposed wires is important (see the
RS-232 connector
information).
Analog video connectors
The universal analog video boards can accept RGB video and (with
adapters) component video, S-video,and composite video (see
figure 8).
Pin
10 5 1 6
1
2
3
15 11
4
5
Figure 8. Analog Video Connector Wiring
For component video, use the R-(R-Y) and R return pins (pins 1
and 6), G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B
return pins (pins 3 and 9).
For S-video, use the B, B return (C-chroma), G, and G return
(Y-luma) pins.
For composite video, use the G pin and the associated return pin.
Input only sync signals, no video signals, on the sync pins, 13 and
14.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
NOTES
on page 15 for more
Function Pin Function
Red video 6 Red return
Green video 7 Green return
Blue video 8 Blue return
Monitor ID bit 9 Not used
H. sync return 10 V. sync return
XTP II CrossPoint Series • Installation
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Pin Function
11 Monitor ID bit
12 Monitor ID bit
13 H. sync
14 V. sync
15 Monitor ID bit
17