Extron electronics XTP II CrossPoint 1600 Setup Manual page 18

Con gurable digital video matrix switchers xtp ii crosspoint series
Hide thumbs Also See for XTP II CrossPoint 1600:
Table of Contents

Advertisement

NOTE:
page 5, and
2
3
4
XTP CP 4o Fiber 4K (fiber optic output board)
OUTPUTS
XTP OUT
SIG
LINK
LAN
LAN
3 3
5 5
3 3
5
3
4
10
XTP II CrossPoint Series • Installation
See item
on
B
figure 4
XTP power indicators — Indicate the status of the PoX
provided to the endpoint as follows:
Lit green — The board is providing XTP power to the
endpoint.
Lit amber — XTP power is available, but disabled.
Blinking amber — A wiring fault exists.
Unlit — The endpoint cannot receive power over XTP.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN
(Ethernet) connector on the connected endpoint (see
TP connectors
on page 13 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
connect serial RS-232 signals, modulated IR
signals, or both to these 3.5 mm, 5-pole captive
screw connectors for bidirectional RS-232 and IR
communications on the associated inputs (see
IR connectors
on page 15 to wire the connectors).
XTP OUT
XTP OUT
SIG
LINK
SIG
LAN
5 5
3 3
5 5
XTP Out connectors — Connect up to four
fiber optic cable between these ports and the
Tx port of a compatible Extron fiber optic
receiver.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN
(Ethernet) connector on the connected endpoint (see
TP connectors
on page 13 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
connect serial RS-232 signals, modulated IR
signals, or both to these 3.5 mm, 5-pole captive
screw connectors for bidirectional RS-232 and IR
communications on the associated inputs (see
IR connectors
on page 15 to wire the connectors).
figure 2
on page 4,
on page 6.
XTP OUT
RS-232
LINK
SIG
LINK
Tx Rx G Tx Rx
LAN
3 3
5 5
figure 3
on
LAN
RS-232
Tx Rx
RS-232 and
XTP CP 4o FIBER 4K
OVER FIBER
IR
RS-232
IR
RS-232
IR
RS-232
IR
Tx Rx G Tx Rx
Tx Rx G Tx Rx
Tx Rx G Tx Rx
4 4
XTP OUT
SIG
LAN
RS-232
Tx Rx
RS-232 and
IR
Tx Rx
LINK
IR
Tx Rx

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xtp ii crosspoint 3200Xtp ii crosspoint 6400

Table of Contents