Extron electronics XTP II CrossPoint 1600 Setup Manual page 15

NOTE:
page 5, and
2
3
4
XTP CP 4i Fiber 4K (fiber optic input board)
INPUTS
XTP IN
SIG LINK
LAN LAN
3 3 5 5 3 3
5
3
4
See item on
A
figure 4
XTP power indicators — Indicate the status of the power
over XTP (PoX) provided to the endpoint as follows:
Lit green — The board is providing XTP power to the
endpoint.
Lit amber — XTP power is available, but disabled.
Blinking amber — XTP power is not available, but enabled.
Lit red — A wiring fault exists.
Unlit — The endpoint cannot receive power over XTP.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN
(Ethernet) connector on the connected endpoint (see
TP connectors
on page 13 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
connect serial RS-232 signals, modulated IR
signals, or both to these 3.5 mm, 5-pole captive
screw connectors for bidirectional RS-232 and IR
communications on the associated inputs (see
IR connectors on page 15 to wire the connectors).
XTP IN XTP IN
SIG LINK SIG
LAN
5 5 3 3 5 5
XTP in connectors — Connect up to four fiber
optic cable between these ports and the Tx port
of a compatible Extron fiber optic transmitter.
This board uses small form factor pluggable
(SFP) modules with industry-standard LC fiber optics
connectors to provide reliable physical connectivity and
precise fiber core alignment.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN
(Ethernet) connector on the connected endpoint (see
TP connectors
on page 13 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
connect serial RS-232 signals, modulated
IR signals, or both to these 3.5 mm, 5-pole
captive screw connectors for bidirectional RS-232 and IR
communications on the associated inputs (see
IR connectors on page 15 to wire the connectors).
figure 2 on page 4,
on page 6.
XTP IN
RS-232
LINK SIG LINK Tx Rx G Tx Rx
LAN
3 3 5 5
XTP II CrossPoint Series • Installation
figure 3 on
LAN
RS-232
Tx Rx
RS-232 and
XTP CP 4i FIBER 4K
OVER FIBER
IR RS-232 IR RS-232 IR RS-232 IR
Tx Rx G Tx Rx Tx Rx G Tx Rx Tx Rx G Tx Rx
4 4
XTP IN
SIG
LAN
RS-232
Tx Rx
RS-232 and
IR
Tx Rx
LINK
IR
Tx Rx
7