Number Of Connections; Establishing A Usb Port Connection; Host-To-Switcher Instructions; Common Sis Command Symbols - Extron electronics XTP II CrossPoint 1600 Setup Manual

Number of Connections

A switcher can have up to 200 simultaneous TCP connections,
including all HTTP sockets and Telnet connections. When
the connection limit is reached, the switcher accepts no new
connections until some have been closed. No error message or
indication is given that the connection limit has been reached. To
maximize the performance of your switcher, keep the number of
connections low and close unnecessary open sockets.

Establishing a USB Port Connection

A standard USB cable and the Extron DataViewer utility, version
2.0 or newer, can be used for connection to the XTP II CrossPoint
matrix switcher Configuration port. The USB cable, available at
any local electronics store, should be terminated on one end with a
USB mini-B male connector.
NOTE:
the USB driver on your computer. The simplest way to do
this is to install the XTP System Configuration software and
then run the Found New Hardware Wizard.

Host-to-Switcher Instructions

The switcher accepts SIS commands through its serial port, its
USB port, or its LAN port. SIS commands consist of one or more
characters per command field. They do not require any special
characters to begin or end the command character sequence.
Each switcher response to an SIS command ends with a carriage
return and a line feed (CR/LF =
response character string. A string is one or more characters.
NOTE:
list of SIS commands. For a complete listing, see the
XTP II CrossPoint Series User Guide.

Common SIS Command Symbols

The following symbols are used throughout the command and
response tables, which start on
• = Space
]
= Carriage return and line feed
}
= Carriage return (no line feed)
|
= Pipe (can be used interchangeably with the
E
= Escape key (hex 1B)
W = Can be used interchangeably with the
24 XTP II CrossPoint Series • Remote Control
Before you use the USB port for the first time, install
The tables that begin on the next page are a partial
]
), which signals the end of the
page 26.
E
character
}
character)