Yealink CP960 User Manual page 49

Tap to accept the change or
7.
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
Tap Settings from the Home screen.
1.
Enter the admin password (default password: admin) from the Advanced block.
2.
Tap Network->WAN Port->IPv6.
3.
Tap the Type field.
4.
Tap Static IP in the pop-up dialog box.
5.
Enter the desired value in the IP Address, IPv6 IP Prefix, Gateway, Primary DNS and
6.
Secondary DNS field respectively.
Tap to accept the change or
7.
If you are using an xDSL modem for IPv4 network connection, you can connect your phone to
the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a
PPP negotiation to obtain the IP address. Contact your system administrator for the PPPoE user
name and password.
To configure PPPoE via phone user interface:
Tap Settings from the Home screen.
1.
Enter the admin password (default password: admin) from the Advanced block.
2.
Tap Network->WAN Port->IPv4.
3.
Tap the Type field.
4.
Tap PPPoE in the pop-up dialog box.
5.
to cancel.
to cancel.
Getting Started
49