Table of Contents
Advertisement
User Guide for CP960 IP Pho
Connect the Power and Wired Network
To connect the power and wired network:
Connect the Ethernet cable between the Internet port on the IP phone and PoE port on the
1)
PoE adapter.
The IP phone should be used with Yealink original PoE adapter (54V/0.56A) only. The use of the
Note
third-party PoE adapter may cause the damage to the phone.
replaced at once if its skin is broken.
Important! Do not remove power to the phone while it is updating firmware and configurations.
Connect the CP Wired Expansion Mic CPE90
To connect the CP Wired Expansion Mic CPE90:
Connect the end of the CPE90 cable to one of the Mic ports on the phone.
1.
Note
Up to two CPE90 can be connected to an IP phone. For more information on CPW90, refer to
Using the CP Wired Expansion Mic CPE90
28
ne
on page 241.
The cable and wire should be
Hide quick links:
Advertisement
Table of Contents
