Jtag Connector; Trigger Connector; Expansion Connector (Tiva J3); Arm Cortex 10-Pin Jtag Connector (Tiva J4) - Texas Instruments DLP NIRscan User Manual

JTAG Connector

The corresponding connector terminal (crimp) part numbers are:
• JST part number: SSH-003T-P0.2
• Digi-Key part number: 455-1561-1-ND
Tiva PA2 (GPIO, UART4 receive or SSI0 clock)
Tiva PA3 (GPIO, UART4 transmit or SSI0 frame sync)
Tiva PA4 (GPIO or SSI0 Data0)
Tiva PA5 (GPIO or SSI0 Data1)
Tiva PK2 (GPIO or UART4RTS)
Tiva PK3 (GPIO or UART4 CTS)
F.4 JTAG Connector
The ARM Cortex 10-pin JTAG connector (J4) of the Microprocessor Board requires an adapter to interface
to the standard TI 14-pin and 20-pin emulators. Refer to the
information.
DESCRIPTION
Key (no connect)
F.5

Trigger Connector

The trigger connector (J500) of the DLPC150 board requires the following 9-pin, 1-mm connector part
numbers:
• JST part number: SHR-09V-S-B
• Digi-Key part number: SHR-09V-S-B
The corresponding connector terminal (crimp) part numbers are:
• JST part number: SSH-003T-P0.2
• Digi-Key part number: 455-1561-1-ND
Note that this connector is on the top side of the DLPC150 board covered by the plastic cover. To access
this connector, the microprocessor and DLPC150 boards must be disassembled from the optical module.
Do not remove the top cover because it protects the optical module from dust and keeps the lenses in
place.
56
DLP NIRscan Nano Connectors
Table F-3. Expansion Connector (Tiva J3)
DESCRIPTION
Power
Ground
Ground
Tiva wake
Table F-4. ARM Cortex 10-pin JTAG Connector (Tiva J4)
Power
TMS
Ground
TCK
Ground
TDO
TDI
Ground
RESETz
Copyright © 2015, Texas Instruments Incorporated
PIN
1
2
3
4
5
6
7
8
9
10
TI JTAG Connector wiki page
PIN SUPPLY RANGE
1
2
3 Ground
4
5 Ground
6
7
8
9 Ground
10
DLPU030B – June 2015 – Revised July 2015
www.ti.com
SUPPLY RANGE
3.3 V
Ground
3.3 V
3.3 V
3.3 V
3.3 V
3.3 V
3.3 V
Ground
3.3 V
for more
3.3 V
3.3 V
3.3 V
3.3 V
—
3.3 V
3.3 V
Submit Documentation Feedback