Table of Contents
Advertisement
F.1
Battery Connector
The battery power (J6) connector of the microprocessor board requires the following 2-pin, 2-mm
connector part numbers:
•
JST part number: PHR-2
•
Digi-Key part number: 455-1165-ND
The corresponding connector terminal (crimp) part numbers are:
•
JST part number: SPH-002T-P0.5L
•
Digi-Key part number: 455-2148-1-ND
NOTE:
The preferred connection to the battery may be a direct solder type or any low resistance
contact connection.
F.2
Battery Thermistor Connector
The battery thermistor connector (J7) of the microprocessor board requires the following 2-pin, 1-mm
connector part numbers:
•
JST part number: SHR-02V-S-B
•
Digi-Key part number: 455-1377-ND
The corresponding connector terminal (crimp) part numbers are:
•
JST part number: SSH-003T-P0.2
•
Digi-Key part number: 455-1561-1-ND
F.3
Expansion Connector
The expansion connector (J3) of the microprocessor board requires the following 10-pin, 1-mm connector
part numbers:
•
JST part number: SHR-10V-S-B
•
Digi-Key part number: 455-1385-ND
DLPU030B – June 2015 – Revised July 2015
Submit Documentation Feedback
DLP NIRscan Nano Connectors
Table F-1. Battery Power Connector (Tiva J6)
DESCRIPTION
Power positive
Ground
Table F-2. Battery Thermistor Connector (Tiva J7)
DESCRIPTION
Power positive
Ground
Copyright © 2015, Texas Instruments Incorporated
DLPU030B – June 2015 – Revised July 2015
PIN
SUPPLY RANGE
1
4.2 V
2
Ground
PIN
SUPPLY RANGE
1
4.9 V
2
Ground
Appendix F
DLP NIRscan Nano Connectors
55
Advertisement
Table of Contents
