Dlp Lightcrafter Single Dlpc900 Connections; Figure 5-3. Dlp Lightcrafter Single Dlpc900 Evm Connectors (Top View); Table 5-1. Dlp Lightcrafter Single Dlpc900 Evm Connector Reference - Texas Instruments DLPC900EVM User Manual

www.ti.com

5.5 DLP LightCrafter Single DLPC900 Connections

Figure 5-3 depicts the switches and connectors with their respective locations. Note: Power supply (and cable),
USB cable, and display cable are NOT included with the module.
J18
D8
J8
J10
J11
SW1
J12
J23

Figure 5-3. DLP LightCrafter Single DLPC900 EVM Connectors (Top View)

Table 5-1. DLP LightCrafter Single DLPC900 EVM Connector Reference

Connector
EVM Function
Reference
SW1 Hardware Reset Switch
J1 HDMI Input
J2 DisplayPort Input
J3 EDID jumper (HDMI)
J4 EDID jumper (DisplayPort)
J5 OCLKA output
J6 DLPC900 debug UART
J7 Host USB interface
DLPU101C – DECEMBER 2020 – REVISED MAY 2023
Submit Document Feedback
J17 D9 J2
J9 J16
When pressed resets the DLPC900 controller. When released, the controller boots
from reset.
HDMI video input (primary).
DisplayPort video input (secondary).
When jumper is installed, the EDID prom for the HDMI interface can be updated.
When jumper is installed, the EDID prom for the DisplayPort interface can be updated.
User configurable DLPC900 output clock for additional user on board logic. Pin 1 =
OCLKA; Pin 2 = GND
DLPC900 UART interface for debug messages to a terminal
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Flow Control: None
• Pin 1 = 3.3 V
• Pin 2 = TX out
• Pin 6 = Ground
LVTTL compatible only
DLPC900 USB interface for Host communications with DLPC900
DLP® LightCrafter™ Single DLPC900 Evaluation Module (EVM) User's Guide
Copyright © 2023 Texas Instruments Incorporated
DLP LightCrafter Single DLPC900 EVM Overview
J1 J7
J6 J5 J26
Description or Use
J4
J3
J21
J20
J19
J13
J25
J14
J24
J15
J22
D5
D6
9