Connecting The Plc Main Unit - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
1.4.4

Connecting the PLC main unit

Connect the PLC main unit and the positioning unit with a PLC connection cable FX
5EC (which is offered as an accessory) or FX
• Up to eight positioning units can be connected to the FX
ing units can be connected to the FX
• When connecting the positioning unit to the FX
is required.
(When connecting the positioning unit to the FX
is not required.)
• Only one extension cable FX
• An extension block, extension unit, special block or special unit connected to the connector
c shown in the figure above is treated as an extension unit of the PLC main unit.
When extending I/O points to the FX
vided on the right side of the FX
(I/O points cannot be extended to the FX
• Securely connect cables such as extension cables and memory cassettes to specified
connectors.
Imperfect contact may cause malfunction.
• Turn off the power at first, then connect/disconnect the cable such as an extension cable.
If you connect/disconnect a cable while the power is supplied, the unit may fail or mal-
function.
-GM-65EC (which is separately sold).
2N
Series PLC.
2NC
2NC
2N
-GM-65EC (650 mm) can be used in one system.
2N
-20GM, connect them to an extension connector pro-
2N
-20GM.
2N
-10GM.)
2N
Series PLC. Up to four position-
2N
Series PLC, the interface FX
Series PLC, the interface FX
Introduction 1
-GM-
2N
-CNV-IF
2NC
-CNV-IF
2NC
1-7