Flashforge Dreamer User Manual page 58

5. Now the printer is connected with FlashPrint. A status box at the lower right corner
will show the temperature of both extruders and the platform.
6. Click [Print] icon, and a printing options screen will appear. Make sure that
"ABS" Material Left. Advanced settings can be set under [More
is selected under
Options] . Check the box "Print When Slice Done" and click [OK].
7. Save the file at any location, and the object will start slicing
8. After slicing the object, it will automatically upload the gcode to the Dreamer.
9. After the gcode is done uploading, the printer will go preheating. The Dreamer will
begin printing once it has finished preheating.
Printing from SD Card
1. Click [Print], and a printing options screen will show up.
2. Make sure that the "Material Left" is selected as "ABS." Advanced settings can be
[More Options]
set under icon.
3. Click [OK], and save the gcode file in the SD card.
4. FlashPrint will begin slicing the 3D model.
5. After slicing the object, take the SD card out from the computer. Insert it into the
SD card slot onto the Dreamer.
6. Turn on the Dreamer. Make sure the build plate is leveled and filament is loaded on
the left extruder.
7. Tap [Print] SD Card
and then tap the middle icon.
8. A list of file(s) will show up, tap the file that you would like to print, and tap [Yes].
9. The printer will now enter preheating and will start printing once it finishes
preheating
Printing via Wi-Fi
1. Turn on Dreamer. Make sure the build plate is leveled and filament is loaded on the
left extruder
2. Turn on Wi-Fi on the Dreamer. Then tap [Tool]-[Setting]-[WiFi]-[WiFi ON].
Dreamer User Guide | www.FlashForge.com 400- 699-1063
58