Flashforge Dreamer User Manual page 40

a. Top Solid Layer: Maximum is 30, minimum is 1.
b. Bottom Solid Layer: Maximum is 30, minimum is 1.
● Infill
a. Fill Density means fill rate.
b. Fill Pattern is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to the layer
thickness. The combined thickness should not exceed 0.4mm. "Every N layers" is for
all the infills while "Every N inner layers" is only for inner infills, which generally
can save print time.
● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower speed
is, the better print you will get. For PLA printing, 60 is recommended.
b. Travel Speed is to control the moving speed of the extruder under
non-printing status during work. For PLA printing, 80 is recommended.
Note: Modify parameters settings to get better prints as different models need
different parameters.
● Temperature
Right Extruder Temperature: Recommended extruder temperature is 220℃.
Note: Different temperatures have subtle influences in printing. Please adjust the
temperature according to the condition in order to get a good print.
Platform Temperature: To set the temperature of Platform.
Dreamer User Guide | www.FlashForge.com
6-14
40
400- 699-1063