Flashforge Dreamer User Manual page 25

2. （5-2）Take out the leveling card (Leveling video can be acquired by scanning the
QR Code)
3. （ 5-3 ） Once the extruder and build plate stop moving, slide the piece of paper
continuously back and forth between the nozzle and the build plate. And
simultaneously adjust the knob until the paper causes a slight friction.
[NEXT]
4. （5-4）Tap
the paper back and forth again, and adjust the screw to create the same amount of
friction as the previous step.
Dreamer User Guide | www.FlashForge.com
5-3
5-4
and wait for the extruder to move to the second position. Slide
5-5
25
400- 699-1063