VERITAS NetBackup 523 Installation Manuals page 48

48 Verifying the operation of the appliance and configuring IPMI
Turning on the appliance
3
Verify that each storage shelf has been turned on and is running properly.
4
Turn on the appliance, using the power button which is located on the right
side of the front panel.
5
Determine if the NetBackup appliance is running properly.
Check the Status LED (1), and Activity (2) LED on the installed disk drives
■
on the front panel.
The Status LED (1) should not be lit. The following indications are possible:
A solid, amber, LED indicates a disk fault.
■
A blinking, amber, LED indicates that a RAID rebuild is in progress.
■
The Activity LED (2) indicates the following:
The LED is not lit when the disk has spun down, although power is on.
■
The LED is solid green when there is no disk activity, although power
■
is on.
The LED blinks green when the disk spins up.
■
The LED blinks green occasionally when commands are processed.
■
Review all LEDs on the front control panel.
■