How To Control The Unit - ACME FURY LED RGB User Manual

4.3 Home Position Adjust
Press Enter button for about 5 seconds, "OPAN" will shown on the display, press ENTER
button to confirm, then use DOWN and UP button to adjust the home position (-127 - 127) of
the motor. Once the position has been selected, press the ENTER button to setup or exit the
offset mode without any change press the MENU button.

5. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show "L308" on the
display. After that the unit will be ready to receive DMX signal or run the built in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
(random show),
have nothing plugged into it, and Its master LED will be constantly on and sound LED will
flash to the music. The other units will have to select
show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the
slave led lights will constantly on.
2-light show
In slave mode,
show. In order to create a great light show, you can set
contrast movement to each other, even if you have two units only.
(show 1) or ...or
means the unit works as the master unit and
(show 8). Its DMX input jack will
8A
and select
(normal) or
means 2-light
on the second unit to get
(2 light