ACME FURY LED RGB User Manual page 8

button.
LED display
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select
(display off) mode. Once select, press ENTER button to setup or exit menu mode
without any change after 30 seconds. Back to the functions without any change press
MENU button again.
Display Inverse
Press MENU button until
select (normal) or
functions without any change press MENU button.
Self-Test
Press the MENU button up to when the
button and the unit will run the built-in programmer for self-test. To go back to the functions
press the MENU button.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button.
Reset
Press the MENU button up to when the
button and all the motors will back to their home position.
is shown on the display. Pressing ENTER
is blinking on the display. Use DOWN and UP button to
(inverse), press ENTER button to setup. Back to the
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
7A
(display on) or